Your cart has been successfully updated.
An error occured while trying to update your cart.
  • Inductive sensor adapter board
  • Inductive sensor adapter board
  • Inductive sensor adapter board
  • Inductive sensor adapter board

Inductive sensor adapter board

Ramps adapter board for inductive sensor rev2.0
7,00 € VAT inc.
5,83 € VAT exc.Eco-participation : 0,01 € VAT inc.
To prevent automated spam submissions leave this field empty.
This board allows you to connect an inductive or capacitive sensor directly on the Ramps board.

Features:
  • LED signal indicator (signal inverted)
  • 4 connectors:
    • female on the 12V of the Ramps board
    • female on the D12 VCC 5V pins of the Ramps board
    • male dedicated to the inductive sensor
    • male for 12V output (e.g. fans)
  • Insulation of the 12V and 5V with an Opto-isolator
  • Dimensions: 26 x 21mm
Note: If needed you can rewire the E/S to be compatible with any other controller board

How to use the board:
Before anything: Please download the last Marlin firmware https://github.com/MarlinFirmware/Marlin
Usually, Zprobe is connected to the Zmin pin, so you will have to change several things:
  • In configuration.h: configure the following line, "const bool Z_MIN_ENDSTOP_INVERTING = true; // set to true to invert the logic of the endstop."
  • In pins.h: in the Ramps configuration (motherboard 33) configure the Zmin pin to D12 : "#define Z_MIN_PIN          12 //  18 " (it should be around the line 612)
Caution: If you are configuring yourself the firmware do NOT forget to set the pinout to the "INPUT" mode. ("OUTPUT" mode will damage this board)

Changelog:
13/10/2015: Rev2.0, LED added. Smaller board, better and stronger connectors. Board specialized for NPN sensors. Licence is now GPL V2
 
Cookies help you get a better experience. By using this site, you accept the use of cookies.
×